OCTAVE PEDAL VST PLUGIN HOW TO
OCTAVE PEDAL VST PLUGIN FULL
OCTAVE PEDAL VST PLUGIN PRO

One of the most interesting features of this pedal though is the range mode. Switch to Poly and you get a more modern octave sound, tracking excellently no matter how complex your chords are.

Vintage mode recreates the mono sound of the original OC-2, which means it’s great for single note lines, but gets confused if you try and add chords into the mix. The OC-5 has two modes for you to play with, vintage and poly. The original Boss OC-2 was loved by guitar and bass players alike, and this iteration keeps all that was good about it whilst adding some extra versatility. There are some intriguing features in the Boss OC-5 Octave, so much so that many guitar players are replacing traditional favorites with one of these brown bad boys. It tracks incredibly well, managing chords and riffs with equal aplomb, and it’s housed in a small unit, meaning it will easily fit on your busy pedalboard. We debated long and hard about which pedal would take the top spot here, but we’ve gone for the Electro-Harmonix Nano POG.

OCTAVE PEDAL VST PLUGIN HOW TO

If you want to learn more about how to use octave pedals then head down to the buying advice section of this article. There’s a whole load of choices out there, so we’ve rounded up our top picks for your consideration. It’s the kind of effect that is super easy to set up, yet can make a massive difference to your overall sound. It’s core to the sound of Royal Blood, The White Stripes, and Rage Against The Machine to name just a few, capable of delivering super heavy guitar sounds, as well as some out-of-this-world tones.Īdding an octave pedal to your setup is a no-brainer. Included are some presets that run through the capabilities of the plug-in.The sound of an octave pedal has been all over modern guitar for some time now, with everyone from classic heroes like Hendrix and Page, right through to sonic pioneers like Johnny Greenwood and Matt Bellamy utilizing them. This plug-in has the capability to easily reproduce this mod, by adjusting only a few parameters. Many users of the Boss OC-2 pedal seek to add a hardware modification that disables the output filter and dynamics sections in order to produce a more synth-like tone. 'Listen' radio buttons allow the user to tap the audio at any stage to hear what's happening behind the scenes, and bypass certain sections if desired.

Includes a 'Scope Tuning' control to affect the zoom ratio.

OCTAVE PEDAL VST PLUGIN FULL

In phase-multiplier mode, the full dynamics of the key signal are retained.Ī DC-offset switch corrects the input signal to improve tracking on rectified or offset signals.Ī scope displays both the key signal and the output signal, so the user can see how the plug-in is operating, and help identify what controls need to be adjusted in order to track more accurately or produce the intended sound. In additive mode, dynamics for the oscillators can be controlled either by a noise gate or an envelope follower, both keyed off the input signal. The additive mode simply mixes in the octave down signals (via user-adjustable levels and wet/dry balance), whereas the phase-multiplier mode flips the phase of the key signal, following the state of the selected oscillator. Option for two modes of operation: additive oscillators or phase-multiplier.

OCTAVE PEDAL VST PLUGIN PRO

If you have Pro Tools 10 co-installed and (32-bit) BlueCat PatchWork, or similar, you could download the free VST-32:Ĭontrols to all the typically fixed values for low-pass filters - both on oscillator outputs (changes tone from full square wave to pure sine, or anywhere in between) as well as on the detection circuit (which can fine-tune the accuracy of the octave-divider's tracking).

I'm trying to find a good octaver plugin, ideally a free one, for my PT 12.5 on iMac.

Octave pedal vst plugin